1) the RMS value of the current is? /2) the peak value of the voltage is?/3) the value of the reactive power is? For a certain load Z = 8.88 < 50 ohm , the power ofthe load is 100 W, calculate

Answered: Image /qna-images/answer/703a85c0-58d2-40f9-86c7-e6b03e7d1f4d.jpg

Answered: the RMS value of the current is? /2)…

Engineering

Electrical Engineering

the RMS value of the current is? /2) the peak value of the voltage is?/3) the value of the reactive power is?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 3RQ: 3. What is power factor?

See similar textbooks

Related questions

Q: RMS value ?

A: Given waveform,

Q: Determine the unknown values. Phase Instantaneous Value Peak RMS Average Value Value Value Angle (a)…

Q: 12. a Derive the equation for the RMS voltage in terms of peak voltage for a cosine wave. That is,…

Q: A 29-Ω television and an 16-Ω amplifier are connected in series across a 158-V source of voltage…

A: Given: A 29 Ω television and a 16 Ω amplifier are connected in series across 158 V source and also…

Q: Write the correct answer If the peak to peak voltage is equal to 10. How much the RMS value of the…

Q: b) A device with characteristics as shown is used to control an 110V AC supply. The load is…

A: The I-V characteristics of a device is given in the question. We need to identify the device. Also…

Q: 8. An emf is given by e = 150 sin (314t + 30°) volts. Determine: (a) maximum value, (b) frequency,…

Q: H.W: A sinusoidal waveform, 3v2cosw,t, is added to a second 4v2coswzt, determine the rms value of…

A: Part (a): When the angular frequencies for both the sinusoidal waveform are equal, these signals are…

Q: Determine the following: (a) The components present in the circuit. (b) The rms value of the…

A: Note- Same frequency of voltage produces same frequency of current. Voltage leads current in…

Q: two devices are connected across a source where F= 60 Hz. If the 2 rms values of the voltage drops…

A: The solution is given below

Q: Find the RMS current from 30⁰ to 180⁰ at Im = 10 Amperes

Q: Please explain how you got the rms.

Q: Derive the formula for the RMS value for the following

A: In this question, We need to derive the formula for the RMS value for the following.?

Q: Vpk wt 2n

Q: Find the RMS Valve

A: We will solve for the RMS value of the given triangular wave.

Q: 2. For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on at 500µs/cm and…

A: Given Data: time/cm = 500 us/cm width of cycle = 4 cm peak to peak height = 5cm volt/cm = 5 V/cm

Q: The given data to be used for getting the RMS Values is 0, 5, 10, 30, 50, 70, 50, 30, 10, 5, 0, -5,…

A: In this answer we will find the RMS value using all the given values as explained below. The RMS…

Q: Derive the formula for the RMS value for the following a)

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: Find the RMS valve [Just try

A: From the standard formula we can able to find the root mean square value of any signal

Q: P5.17. Find the rms value of the voltage waveform shown in Figure P5.17 D. V(1) T= 2 Figure P5.17

Q: What are the customary units for real power? For reactive power? For apparent power?

A: Given: To describe the customary units for real power is shown as:

Q: Find the rms value of the current waveform shown in Figure P5.13.

A: Given data: T=4 The expression for the rms value of the current is given as, Irms=1T∫0Ti2tdt

Q: Find the rms value of the voltage waveform shown in Figure P5.17.

A: The function is expressed as: vt=5t2 0<t≤2 The rms value is given as: vrms=1T∫0Tvt2dt

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: Find the rms value of the given waveform

A: Given waveform,

Q: = 500sin(300nt – 75°) te the peak voltage, phase angle,rms value, freq

Q: Derive the formula for the RMS value for the following

Q: Consider the sinusoidal voltage v(t)=100cos(1000nt-65°)V. A. What is the maximum amplitude…

Q: Determine the rms value for each of the waveforms shown in figure below.

A: The root mean square value of any function represents it's effective value affecting the working…

Q: RMS Average Value Peak Phase Instantaneous Value Value Angle Value (c) ? ? 10 A 30° ? (d) 200 V ? ?…

A: in the question a sinusoidal signal is given. V=Vmsinωt Average Value =VmπRMS Value = Vm2

Q: ) Determine the power and rms value for each of the following signals:

Q: 169sin 377t a) What is the RMS value? b) What is the Average value?

A: Given: Let V=169sin 377t

Q: A current of 10 A rms flows when a single-phasecircuit is placed across a 220-V rms source.…

A: Write the given values in the question.

Q: Find the RMS value

A: The wave diagram shows the maximum value of the voltage as Vm.

Q: Find the RMS value of the source voltage, Reactance of C (Xc), Total Impedance, Current in the…

A: In this question, We need to Find the RMS value of the source voltage, Vrms = Vm /√2 Reactance of C…

Q: What is rms value of current (I) and active power delivered by source.

A: Given circuit is - Given values are - V=2×100cos1000tω=1000VRMS=10022∠0oVRMS=100∠0o

Q: FIND THE VALUES INDICATED AND SHOW THE COMPLETE SOLUTION. RMS Phase Angle Peak Instantaneous Average…

Q: Supply voltage has an average value of 20 V. Its RMS value is RMS value, Vrms = %3D

A: If the averages voltage 230V Then rms value? Assume this is sinusoidal waveform.

Q: A series of data is gathered discretely at equal intervals of time from an unknown voltage waveform…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Derive the formula for the RMS value for the output waveform given below.

Q: 3714 Kontrol T14 T/2 -Vp

A: We are authorized to answer one question at a time, since you have not mentioned which one you are…

Q: A complex voltage waveform which has an rms value of 240V contains 30% third harmonic and 10% fifth…

A: Given: Vrms=240V 3rd and 5th harmonic components are present in the voltage wave form. Frequency of…

Q: B) For voltage waveform shown in the below fi., determine the rms, average value, form factor, and…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: 1. Instruction: Provide the correct answer. 1. What is the relationship between the supply voltage…

A: As per bartleby policy there are multiple questions so we have to solve only one question.

Q: 3 Find average value, RMS value and form factor of waveform shown in figure.

A: Given, Imax=5T=1 (time period) RMS value, Taking straight line equation,…

Question

1) the RMS value of the current is? /2) the peak value of the voltage is?/3) the value of the reactive power is?

For a certain load Z = 8.88 < 50 ohm , the power of
the load is 100 W, calculate

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3. By using Thevenin's theorem, calculate the current flowing through the load connected across terminals A and B of circuit shown in the figure below. All resistances and reactances are in ohms. jl5 10 -j8 :-j3 )60 Lo° j4 8 070£
The meter constant of a single phase energy meter is 500 rev/kWh. It is found that with a load of 5 kW, it makes 40 revolutions in 50 sec. The percentage error is ?
5) Determine all the currents and voltages in the figure below. 8A IT wwwww In 2002. Iz 10Ω ww 13 592 2002
The meter constant of a single-phase energy meter is 500 rev/kWh. It is found that with a load of 5 kW, it makes 40 revolutions in 50 sec. The percentage error is?
Find the equivalent resistance seen by the generator 10v. 592 552 10V 302 4 122 Vo 52 72 Select one: a. Req = 15 ohms %3D Ob. Req = 10 ohms %3D C. Req = 20 ohms d. Req = 100 ohms
What is the total apparent, reactive, and real power of the network in figure 1? Also, determine the current Io and the power factor of the system.
Vs SOURCE LINE Figure 1 LOAD
Find the equivalent resistance seen bay generator 10 v
Find the equivalent resistance seen by the generator 10v. 52 50 10V 302 42 122 Vo 52 Select one: a. Req = 15 ohms b. Req = 10 ohms c. Req = 100 ohms d. Req = 20 ohms
1. Determine the peak voltage and the peak power delivered to R, in the following figure: 2:1 115 Vrms eeeee 00000 www RL 220 2
1. Solve for the current of 1+j3 ohms impedance using Kirchhoff's Law. 0.022 0.02 L
A load 100+j0 ohms is connected across a 200 V and 50 Hz supply. Find the total current. a. 1 A b. 2 A c. 3 A d. 3.5 A