A 220V single phase induction motor draws 2.76 kW at 220V and 0.8 pf. A 3 KVA capacitive load is connected across the motor terminals to bring the total power factor to unity. Find the kW of the capacitive load. Ans: 2.17 kW

Q: ›uppose a signal ä(t) has the following two-sided spectrum representation: e-1²- e -1.5 e-¹4 -0.5…

A:

Q: 6-32D Design an RC OP AMP circuit to implement the block diagram in Figure P6-32. vs(t) → d dt 100…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: Given a = 1, b = 1, c = 5, d = 5, e = 5, f = 2, x = 30 and y = 60, in the figure below, use…

A:

Q: Exercise 9.4.13 a b 8 μF HH 3 μF: 6 μF 6 µF = 12 µF About 10 μF (a) Reduce the circuit in the figure…

A: By combining the Capacitors in series and parallel calculate equivalent capacitance seen from ab…

Q: Use KCL to calculate the unkown current / in the circuit below: 2 A 0-4 A -8 A 04 A 3 A

A: Circuit diagram,

Q: For part C, can you put the expression in sum-of-product form please. Not clear

A:

Q: 6.3.2 Find the total capacitance Cr in the network given. All capacitors are in microfarads. CT- 6…

A: We need to find out equivalent capacitance for given circuit.

Q: Find the Norton equivalent for the given circuit at terminals a-b. Given /= 0.5 A. Please report…

A: A linear circuit that have one more dependent or independent sources can be replaced with single…

Q: A combinational circuit is defined by the function F1= ∑ m (3,5,7),                  F2 = ∑ m…

A:

Q: *42. a. Determine V₁, IL, Iz, and IR for the network of Fig. 2.186 if R₁ = 180 N. b. Repeat part (a)…

A: As per our guidelines we are supposed to the first 3 subparts,if a student asks multiple subparts.…

Q: Calculate the force between the two parallel conductors if they are 0.5 m in length and are…

A:

Q: A = 5,2 â+5,5 ay + 7,1 a. if aA = Ka+ Lay+ Mâ, then K+L+M=? **use at least 3 digits after the comma…

A:

Q: A 3-phase overhead line has a reactance of 0.5 pu. The sending end voltage is 128°. In order to…

A: 3-phase overhead line Reactance=0.5 pu Load of receiving end=0.75 pu @ 0.8 pf lagging. 100 MVA base.

Q: 10) In the following RC circuit with a switch S, two resistors R, and R₂ have the same resistance R…

A: Given that , R1=R2=20 ohm E=12v C=15uF. We need to find the time dependency of current through R2 .…

Q: Qu) Draw the block diagram of Generation of PPM

A: We have to draw the block diagram of generation of PPM signal.

Q: Ex:2 Find I, VR. VL and Vc at resonance for the circuit. R AMD XL Xc m1F loske IKR 1K2

A: In this question we need to find the current I , voltage across resistor , voltage across inductor…

Q: 1. A classical rectifier is to be designed to provide 5 V ± 1% for a logic circuit, with output…

A: Vout=5 V±1 %Pout=12 WVin=120 Vf=60 Hz

Q: A six-pulse SCR bridge for a three-phase source draws power from a 500 V, 50 Hz line (the volt- age…

A:

Q: Voltage source is 40VRMS at 1kHz with resistance equal to 2500 and inductance of 33mH. Solve for the…

A: V= 40Vrms f=1KHz L=33mH R=250Ω   Need to calculate the voltage across the resistor.

Q: Memo No.. Date 2/ using Thevenins theorer We Th Fr Sa Su 12V 211 XIX محمد3 34 دا AMA 180 पप

A:

Q: Homework 5 1. In the circuit below, C=10 nF, and R=10 kOhm. A. Find the corner frequency (fc) in the…

A:

Q: Two 22kV single phase generators are connected by a 2292 transmission line. The voltage angle of the…

A:

Q: E3-9. Find I in the circuit of the figure below. 6Ω 24 (1 108 10Ω, 40V( Dea 24 ΔΩ 30V

A: Circuit diagram is given as,

Q: The switch moves from position A to position B at t = 0 30 Ω At=0 ww 80 V dv(0)/dt=-4 V/s ic(0)=-4A…

A: We need to find the following parameters for this circuit  Circuit:-

Q: Question -8: Determine the Norton equivalents of the circuit shown in Figure-8, as seen by an…

A: In this question we need to find the Norton equivalent of the given circuit. To find Norton…

Q: Q2) Find the bandwidth of TDM system have 20 voice channel with 4KHZ message frequency.

A: TDM system having voice channels N=20 message frequency fm=4kHz

Q: 220° Α ΤΩ www ΠΩ m ΖΩ ww ΦΩ Η 4290 A Fig. 6. Using mesh analysis to find Io in the circuit of Fig.…

A:

Q: refer to the figure below Vp Rp Rp = 10 ohms Xp = 3 ohms Rs = 5 ohms Xs = 2 ohms Rc 100 ohms Xm= 50…

A:

Q: Two coils, A and B, are positioned such that 80% of the flux produced by coil A links with B. When…

A: The value of current in the primary, I=5 A The value of flux, ϕ1=2 mWb The number of turns in coil…

Q: (Exercise 3.27) Assume the diode to be ideal, describe the transfer characteristic.

A: For the given clipper circuit the transfer characteristics need to be analyzed by considering the…

Q: Simplify the following truth table using k-map then draw the circiut for the output expression

A: In this question,  We need to determine the output expression and need to draw the circuit.  We are…

Q: Q1. The transfer functions of some linear systems are given below, find (1) the order of each…

A: For the given system of the transfer function, we need to find the order of each system, dc gain,…

Q: The average voltage of a single-phase full controlled bridge converter is measured to be 103.5 V.…

A: A single phase full controlled bridge converter with, Average voltage, Vavg=103.5 V. Supplied…

Q: The A, B, C, D constants of 220 kV line are A = D = 0.9421°, B = 130273°, C = 0.001 90°. If sending…

A: Given the transmission line with, The A, B, C, D constants of a 220 kV line are:…

Q: Q3: Find V, using mesh analysis 3 ΚΩ 4 ΚΩ Μ 2105 10 ν 4 ΚΩ 3 ΚΩ Μ w 0.5V, + - 6 ΚΩ ww Vx + 1+ 6ΚΩΣΤ…

A: In this question we need to find a voltage Vo using mesh analysis.

Q: PROBLEM: For each of the following transfer functions, write, by inspection, the general form of the…

A: Transfer function is also known as a network function . In a transfer function theoretical model…

Q: For a fixed value of complex power flow in a transmission line having a sending end voltage V, the…

A: In this question We need to choose the correct option.  We know  Power P= I2 R

Q: Solue for the power delivered to the 4 resistor.

A: The power observed by the resistor can be calculated by using the mesh analysis and the mesh…

Q: QUESTION 18 The instantaneous contacts of a timer are drawn in the same manner as standard relay…

A: INSTANTANEOUS CONTACTS ALSO KNOWN AS NORMALLY OPEN  OR NORMALLY CLOSED CONTACTS ARE A TYPE OF…

Q: 19. Find the steady-state offset for r=1 of the following system, compensator, sensor and target…

A: a) To find the steady-state offset for the given system, we first need to check the closed- loop…

Q: A mass-spring system with damping consists of a 9-kg mass, a spring with spring constant 3 N/m, a…

A:

Q: A 10 MVA.11 KV, 3-Phase star connected alternator is protected by the Merz-price balance current…

A: In a synchronous generator, the Merz price balance current system is used to find the total…

Q: Q2. Write the transfer functions for: (5) A second order system with a de gain of 2, natural…

A: In this question we need to find the transfer function of the given 2nd order system.

Q: Use the waveforms of a, b, and c below to find the power dissipated in the two resistors and the…

A: For the given voltage supply it  is asked to find the power dissipated in the resistor and rms value…

Q: 18. A dc-dc converter is to be built with the following specifications: Allowed dc input voltage…

A: Types of Basic DC DC Converter  Buck converter  Boost converter  Buck boost converter

Q: Find the following: 1=e-²t 8(t-2) dt y(t)=x (t-4). 8(-t-5) y(t)= [u (t-3)-u(t-5)] u(t) (Find and…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: 5. The current in a 100-mH inductor is i(t) = 2 sin377t A. Find (a) the voltage across the inductor…

A: Inductance L= 100 mH. Current is given it=2sin377t A.

Q: onsider an infinitely-long charged line aligned with the x axis. In this case, the strenght of the…

A: We need to select correct option for charged line field .

Q: 26. Find equivalent capacitance of the combination shown in Fig. P1.16 and Fig. P1.17.

A: It is given that:

Q: Draw 2-input NOR gate using CMOS logic family?

A:

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.