*17-36. The dresser has a weight of 80 lb and is pushed along the floor. If the coefficient of static friction at A and B is μ, = 0.3 and the coefficient of kinetic friction is µ = 0.2, determine the maximum horizontal force P that can be applied without causing the dresser to tip over. Problems 17-35/36 2.5 ft 1.5 ft 1.5 ft- B 4 ft

*17-36. The dresser has a weight of 80 lb and is pushed along the floor. If the coefficient of static friction at A and B is μ, = 0.3 and the coefficient of kinetic friction is µ = 0.2, determine the maximum horizontal force P that can be applied without causing the dresser to tip over. Problems 17-35/36 2.5 ft 1.5 ft 1.5 ft- B 4 ft

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.90RP: The screw of the clamp has a square thread of pitch 0.16 in. and a mean diameter of 0.6 in. The...

See similar textbooks

Similar questions

The two homogeneous bars AB and BC are connected with a pin at B and placed between rough vertical walls. If the coefficient of static friction between each bar and the wall is 0.25, determine the largest angle 6 for which the assembly will remain at rest.
The screw of the clamp has a square thread of pitch 0.16 in. and a mean diameter of 0.6 in. The coefficient of static friction between the threads is 0.4. Determine (a) the torque C0 that must be applied to the screw in order to produce a 28-lb clamping force at A; and (b) the torque required to loosen the clamp.
The leather rein used to fasten the horse to the hitching rail weighs 3.5 oz per foot. The coefficient of static friction between the rail and the rein is 0.6. If a 34-lb force acting on the bridle is sufficient to restrain the horse, determine the smallest safe length L for the free end of the rein.
2 of 8 8-6. The 180-Ib man climbs up the ladder and stops at the position shown after he senses that the ladder is on the verge of slipping. Determine the coefficient of static friction between the friction pad at A and ground if the inclination of the ladder is e = 60° and the wall at B is smooth. The center of gravity for the man is at G. Neglect the weight of the ladder. 10 f 2
If A=1kg, B=2kg, C=12kg, and the static of coefficient friction is equal to 0.04 Determine the normal force exerted by the horizontal plane to block B. Find the force F required to start C moving forward. Nb=? F=?
M. 0.3 m The block brake is used to stop the wheel from rotating when the wheel is subjected to a couple moment. Determine the smallest force P that should be applied as well as the magnitude of the corresponding reaction force at support C. Use the couple moment Mo = 430 N-m, the coefficient of static friction between the wheel and the block of 0.6, a = 1.8 m, b = 0.8 m, and c = 0.075m. Round all answers to the nearest integer. The smallest force P that should be applied is: N. The magnitude of the reaction force at support C is: N.
The 50-Ib cylinder is attached to a cord which passes over the drum. If the coefficient of static friction at the drum is Ms = 0.3, determine the maximum vertical force P that can be applied to the roller when 0 = 30° without causing the cylinder to move.
The drum has a weight of 100 lb and rests on the floor for wich the coefficient of static friction is Ms = 0.5 If a = 3 ft and b = 4 ft, determine the smallest magnitude od the force P that will cause impending motion of the drum.
6 of 8 *8-44. The 3-Mg rear-wheel-drive skid loader has a center of mass at G. Determine the largest number of crates that can be pushed by the loader if each crate has a mass of 500 kg. The coefficient of static friction between a crate and the ground is Hy = 0.3, and the coefficient of static friction between the rear wheels of the loader and the ground is u = 0.5. The front wheels are free to roll. Assume that the engine of the loader is powerful enough to generate a torque that will cause the rear wheels to slip. Fa75 m 025 m
Determine the smallest force P that must be applied in order to cause the 150 lb uniform crate to move. The coefficient of static friction between the crate and the floor is us=0.5.
3. The ladder has a uniform weight of 80 lb and rests against the wall at B. If the coefficient if static friction at A and B is µ = 0.40, determine the smallest angle 0 at which the ladder will not slip. 15 ft
Based on Problem 8-13 from the textbook. The brake is to be designed to be self locking, that is, it will not rotate when no load P is applied to it when the disk is subjected to a clockwise couple moment Mo. Determine the distance d of the lever that will allow this to happen. The coefficient of static friction at B is H₂- Us=0.48 a=0.6ft P a Mo 1 ft